COMET SP044 Lorawan Gateway kit

သတ်မှတ်ချက်များ

• မော်ဒယ်- Milesight UG63
• Wx9xx စီးရီး အသံလွှင့်စက်များအတွက် ရွေးချယ်နိုင်သော ဆက်စပ်ပစ္စည်းများ
• ထုတ်လုပ်သူ- COMET စနစ်၊ sro
• လိပ်စာ- Bezrucova 2901, 756 61 Roznov pod Radhostem, Czech Republic

ဖော်ပြချက်နှင့် အသုံးပြုမှု

• The gateway serves as an access point for the local LoRaWAN® network and is designed to connect the COMET Wx9xx series of wireless sensors to the COMET Cloud.
• After installation, it immediately begins receiving and sending data messages to and from the LoRaWAN® network via its antenna.
• This third-party product is supplied with all the original accessories required for power supply and installation.
• The gateway serves as an access point for the local LoRaWAN® network and is designed to connect COMET Wx9xx series transmitters to the COMET Cloud via the LoRaWAN® network.
• The gateway is a third-party product, supplied with complete original accessories for its power supply and installation. However, it is preset so that after installation it immediately starts receiving data messages from the LoRaWAN® network with its antenna, supplements them with the correct time of message receipt and sends the complete data to the target server used by the
• COMET Cloud. The condition is a connection to a network with available Internet, without restrictions on the outgoing direction from the gateway, e.g. by a firewall. A DHCP server must also be available in this network.
• The gateway is configured via WiFi, see the original device manual. Under normal circumstances, it is not necessary to interfere with the gateway configuration, it is already set.
• Warning: if you reset the gateway to factory settings, all presets will be lost!
• Registering a gateway to the COMET Cloud is done in the Administration / LoRa Gateways menu. Add your gateway to the list by entering its Gateway EUI identifier (for this gateway, it is the EUI item from the label on the bottom of the device, under the mounting cover). You can also give it a suitable name and, if it will be placed stationary, we recommend entering its location on the map.
• Connect the gateway as shown in the image below. To maintain cybersecurity, we recommend connecting the gateway to a separate VLAN. Connect the registered gateway to power. Within a few minutes, its status in the gateway list in the COMET
• Cloud must change to ONLINE (you must refresh the web page manually).

RECOMMENDED GATEWAY CONNECTION

Registering the Gateway:

To register the gateway to the COMET Cloud, follow these steps:

1. Access the Administration/LoRa Gateways menu on the original device.
2. Enter the Gateway EUI identifier (found on the label under the mounting cover).
3. Add the gateway to the list and provide a suitable name and location if needed.

Gateway ချိတ်ဆက်ခြင်း။

Connect the gateway following these instructions:

1. Connect the gateway as shown in the provided image.
2. For cybersecurity, connect the gateway to a separate VLAN.
3. Power up the registered gateway.
4. Within a few minutes, check the status in the COMET Cloud; it should change to ONLINE.

နည်းပညာဆိုင်ရာဒေတာ

အထွေထွေအဆင့်သတ်မှတ်ချက်များ

1. LoRaWAN® network frequency band: EU863-870
2. အများဆုံး ပါဝါသုံးစွဲမှု- 3.1 W
3. အီသာနက်- 10/100 Mbps
4. LoRa antenna: External, swivel

အမေးအဖြေများ

Q: What should I do if I accidentally reset the gateway to factory settings?

A: If you reset the gateway to factory settings, all presets will be lost. You will need to reconfigure and register the gateway to the COMET Cloud following the initial setup steps.

Q: How do I find the Gateway EUI identifier?

A: The Gateway EUI identifier is located on the label under the mounting cover of the device. It is a uniqueidentifier used for registering the gateway to the COMET Cloud.

စာရွက်စာတမ်းများ / အရင်းအမြစ်များ

COMET SP044 Lorawan Gateway kit [pdf] အသုံးပြုသူလက်စွဲ SP044, UG63, SP044 Lorawan Gateway kit, SP044, Lorawan Gateway kit, Gateway kit, kit

ကိုးကား

• အသုံးပြုသူလက်စွဲ